- 3 pieces included for ambidextrous and non-ambi setups
- Pair with SI Pistol Grip for better ergonomics, no pinched fingers
- Short but wide for easy-to-reach control
- Grooves for non-slip operation
- Made from durable and lightweight polymer
- Drop-in installation
- Material: Polymer
- Finish: Black
- Weight: 0.1 oz.
- Width: 0.67"
- Height: 0.59"
- Length: 0.96"
- All CZ Scorpion EVO models
- 2x Selector Switches
- 1x End Cap
- 2x M3 Set Screws
- 1x Hex Key
- 1x Loctite Threadlocker Blue 242
The Strike Industries CZ Scorpion safety selector switch is designed to replace your factory safety switch to allow quicker and easier engagement and disengagement of your AR safety over the original factory CZ selector switch.
The CZ Scorpion safety switch is short but wide for easy on/off control and is grooved for positive non-slip operation even when operating under the wettest conditions. The safety switch pairs perfectly with the 15-degree angle of the SI pistol grip for optimal ergonomic operation without the risk of pinching your fingers. The grip is sold separately.
The Strike Industries CZ Scorpion safety three-piece design can be set up for either- side ambidextrous and non-ambidextrous functions to allow you to configure the setup as you wish. The switch is made from a lightweight, durable polymer and weighs in at just 0.1 ounces. At just 16.90mm wide by 14.95mm high and 24.5mm long, the switch is short, wide and intuitively easy to reach and operate.
The Strike Industries CZ Scorpion switch is designed for simple drop-in installation with the included hex-head key.