• Lightweight single piece design
  • Simple rock-on and tighten mount to Mil-Spec Picatinny rail
  • Available in Absolute Co-Witness Height and 1.93" Height
  • Made in the U.S.A.


  • Material: 7075-T6 Aluminum
  • Finish: Type III Hardcoat Anodized
  • Weight:
    • Absolute Co-Witness: 1.02 oz.
    • 1.93" Height: 1.31 oz
  • Length: 1.76"
  • Width: 1.13"


  • Aimpoint Micro H-1, H-2, T-1,T-2
  • Burris Fastfire RD
  • Primary Arms Micro Dots
  • US Optics TSR-1X
  • MAKdot S 1x20
  • Blaser RD 17
  • Vortex Crossfire, Sparc AR, Sparc Solar
  • Minox RV1
  • Holosun 403 models (except the ‘A‘ model)
  • Holosun 503, 515, 530
  • Sig Sauer Romeo4, Romeo 5
  • DI Optical SP1
  • Athlon Midas TSR2
  • Actus Core-1 1x20, Core-2 1x20e-2 1x20
  • Sightmark Wolverine
  • Swampfox Liberator 1x22
  • Vector Optics Maverick 1x22


  • 1x Battlearms Aimpoint Lightweight Optic Mount
  • 4x M3-0.5 x 4mm 6-lobe Torx Screws
  • 2x 8-32x1 Socket Cap Screws


Over the last few decades, some of the more innovative firearm technology has been done in optics. Modern optics and red dot sights can make shooting a lot easier, and allow operators to be accurate and faster.

However, modern optics have more chances to fail than normal irons sights. Though batteries on high-end optics can last for quite a long time, if they run out in the field, you might end up with no sights. Therefore, many people opt to use mounts for their optics, that allow operators to co-witness their iron sights through the optic.

Aimpoint is one of the biggest brands when it comes to red dot sights and modern optics. If you use an Aimpoint on your rifle, you should check out the Battle Arms Aimpoint Lightweight Optic Mount. It has a single-piece lightweight design, made from 7075-T6 Aluminum, and it is available in both Absolute Co-Witness Height and 1.93" Height.

Installing the mount is very simple, and can be mounted simply on any Mil-Spec Picatinny rail.

Have a question?

Ask an Expert